Generac Power Systems LINKTower PLT240, Owner'S Manual

Page: 19 / 28

Operation
Owner’s Manual for PLT240 Light Tower 15
5. See Figure 3-3 . Verify cable winds evenly around
winch drum as shown (A) to prevent cable
damage.
Figure 3-3. Winch Cable Alignment
Prestart Checklist
Before starting the unit, all items in the prestart checklist
must be completed.

Verify all maintenance procedures are up to date. For
more information, refer to
General Maintenance and
Basic Maintenance Schedule .

Verify the unit is level.

Verify the unit is dry. Look for water inside or near the
unit; dry if needed.

For grounding requirements, follow any local, state,
oil and gas or petrochemical plant grounding, MSHA,
OSHA, CSA, IEC, IEEE, NFPA, ABS Marine and
Maritime guidelines as applicable.

Verify the main breaker switch is OFF (O).

Verify all circuit breakers are OFF (O).

Inspect all electrical cords; repair or replace any that
are cut, worn, or bare.

Verify all winch cables are in good condition and
centered on each pulley. Do not use if cables are
kinked or beginning to unravel.

Verify all covers and guards are in place and properly
secured.

Verify cords are routed properly through the water
protection shield.

If using 20A shore power, verify convenience
receptacle is functional.
WARNING
(000372)
Machine damage. Do not extend the mast beyond
the colored mark. Overextension can stretch or
break electrical cables or winch cables, and may
damage mast hardware.
WARNING
Personal injury. Use caution when winding
winch cable. Failure to do so could result
in serious injury.
(000391)
004887
A
(000100a)
WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.