Generator Placement
18
Installation Guidelines for Air-Cooled Generators
4.2 — Fascia Skirt Installation (If Applicable)
Install base fascia as follows:
1.
Remove four rubber mounts from Owner’s Manual bag.
2.
Screw
two
rubber mounts into threaded holes of end piece. See A of Figure 4-3.
3.
Snap end piece into side piece. See B of Figure 4-3.
4.
Fit rubber mounts in end piece into lifting holes at base of generator. See C of Figure 4-3.
5.
Repeat steps 2-4 to install second end and side pieces.
6.
To complete assembly, snap end pieces into side pieces at opposite corners of fascia.
Figure 4-3. Install Fascia Skirt
A
B
C
