Operation
14
Owner’s Manual for 60 Hz Air-Cooled Generators
Intake Side Panel Removal
See
. The intake side panel (A) must be
removed to access the battery compartment, fuel
regulator, and sediment trap.
1.
Raise lid and remove front panel.
2.
Use a hex key to remove two mounting screws (B)
and L-bracket screw (C).
3.
Lift intake panel up and away from the generator.
NOTE:
Always lift intake side panel straight up before
pulling away from enclosure. Do not pull panel away from
the enclosure before lifting up (D).
Figure 3-2. Intake Side Panel Removal
Main Line Circuit Breaker (Generator
Disconnect)
This is a 2-pole breaker rated according to relevant
specifications. See “A” in
The breaker can be locked in the OFF (OPEN) position
for security. Use an appropriately-sized padlock (not
included) with a shackle long enough to pass through
both lock tabs (B).
Figure 3-3. Main Breaker
NOTE:
DO NOT lock out the MLCB during normal
generator operation. Doing so will compromise automatic
standby functionality.
LED Indicator Lights
Figure 3-4. LED Indicator Lights
See
. Three LEDs are visible behind a
translucent lens on the generator side panel. These
LEDs indicate generator operating status.
•
Green LED “Ready” light (A) is illuminated when
utility is present and the control panel is in AUTO
mode. The LED flashes when the automatic
transfer switch converts to generator power during
a utility power outage.
•
Red LED “Alarm” light (B) is illuminated when the
generator is OFF or a fault is detected. Contact an
IASD.
•
Yellow LED “Non-Critical Alert” light (C) is
illuminated when maintenance is required.
NOTE:
Yellow LED may be illuminated at the same time
as either the red or green LED.
D
002961
B
A
C
001810
B
A
B
001791
A
C
B
Summary of Contents for 0065510
Page 43: ......
