CROSSOVER
CROSSOVER
CROSSOVER
CROSSOVER
CROSSOVER
SECTION
SECTION
SECTION
SECTION
SECTION
SYSTEM
SYSTEM
SYSTEM
SYSTEM
SYSTEM
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
AMPLIFIER
AMPLIFIER
AMPLIFIER
AMPLIFIER
AMPLIFIER
SECTION
SECTION
SECTION
SECTION
SECTION
Bass amplifier output power with an 8 Ohm
load:
Short term
120W
Midrange amplifier output power with an 8
Ohm load:
Short term
120W
Treble amplifier output power with an 8 Ohm
load:
Short term
120W
Long term output power is limited by driver
unit protection circuitry.
Slew rate :
80V/µs
Amplifier system distortion at
nominal output:
THD
<0.05%
SMPTE-IM
<0.05%
CCIF-IM
<0.05%
DIM 100
<0.05%
Signal to Noise ratio, referred to full output:
Bass
>100 dB
Midrange
>100 dB
Treble
>100 dB
Mains voltage:
100/200V or 115/230V
Voltage operating range at
230V setting:
207 - 253V (±10%)
Power consumption:
Idle
30W
Full output
200W
Input connector: XLR female
pin1 gnd
pin2 +
pin3 -
Input impedance:
10 kOhm
Input level for 100 dB SPL output @1m:
variable from +6 to -6 dBu
Input level for maximum short term output of
111 dB SPL @1m:
variable from +17 to +5 dBu
Subsonic filter below 38 Hz :
18 dB/octave
Ultrasonic filter above 25 kHz:
12 db/octave
Crossover frequency:
bass/mid 420 Hz
mid/treble
4 kHz
Crossover acoustical slopes:
18 - 24 dB/octave
Crossover level control operating range in 1
dB steps:
bass
from 0 to -6 dB
mid
from 0 to -6 dB
treble
from 0 to -6 dB
Bass roll-off control in 2 dB steps:
from 0 to -8 dB
@42 Hz
Bass tilt control in 2 dB steps:
from 0 to -8 dB
@80 Hz
The 'CAL' position is with all tone controls
set to 'off' and input sensitivity control to
maximum.
Genelec Document
BBA10001
(1010-0107-2)
COPYRIGHT GENELEC OY 1998
Lower cut-off frequency, -3 dB: <42 Hz
Upper cut-off frequency, -3 dB: >25 kHz
Free field frequency response
of system:
43 Hz - 25 kHz (±2.5 dB)
Maximum short term sine wave
acoustic output on axis
in half space, averaged from
100 Hz to 3 kHz:
@1m
>111 dB SPL
@0.5m
>117 dB SPL
Maximum long term RMS acoustic
output in same conditions with IEC-weighted
noise (limited by driver unit protection cir-
cuit):
@1m
>102 dB SPL
@0.5m
>108 dB SPL
Maximum peak acoustic output
per pair on top of console,
@ 1m from the engineer
with music material:
>122 dB
Self generated noise level in
free field @ 1m on axis:
<10 dB
(A-weighted)
Harmonic distortion at 90 dB SPL
at 1m on axis:
freq. <200 Hz
<2%
freq. >200 Hz
<1%
Drivers:
Bass
210 mm cone
Midrange 80 mm cone
Treble
9x65 mm ribbon
Weight:
20 kg (44 lb)
Dimensions:
Height 495 mm (19
1
/
2
")
Width 320 mm (12
5
/
8
")
Depth 290 mm(11
7
/
16
")
Genelec Oy, Olvitie 5
FIN - 74100 IISALMI, FINLAND
Phone:
+358 - 17 - 813 311
Telefax: +358 - 17 - 812 267
E-mail:
Web:
http://www.genelec.com
Genelec Inc, 7 Tech Circle
Natick, MA 01760, USA
Phone:
+1 - 508/652-0900
Fax:
+1 - 508/652-0909
E-mail:
