background image

English 5

Safety Considerations

The 8320A and 8330A have been designed in ac-
cordance with international safety standards. The 
following warnings and cautions must be observed 
to ensure safe operation and to maintain the moni-
tor under safe operating conditions:

• 

Servicing must only be performed by qualified 
service personnel. The monitor must not be 
opened.

• 

Do not use the monitor with an unearthed 
mains cable or an unearthed mains connection.

• 

Do not expose the monitor to water or moisture. 
Do not place any objects filled with liquid, such 
as vases, on the monitor or near it. 

• 

This monitor is capable of producing sound 
pressure levels in excess of 85 dB, which may 
cause permanent hearing damage.

• 

Free flow of air behind the monitor is necessary 
to maintain sufficient cooling. Do not obstruct 
airflow around the monitor.

• 

The device is not completely disconnected from 
the AC mains service unless the mains power 
cord is detached from the device or the mains 
outlet.

Guarantee

This product is guaranteed for a period of two years 
against faults in materials or workmanship. Refer to 
supplier for full sales and guarantee terms.

Compliance to FCC Rules

This device complies with part 15 of the FCC Rules. 

Operation is subject to the following two conditions: 

This device may not cause harmful interference, and this 

device must accept any interference received, including 

interference that may cause undesired operation. 

Note: This equipment has been tested and found to 

comply with the limits for a Class B digital device, pur-

suant to part 15 of the FCC Rules. These limits are de-

signed to provide reasonable protection against harmful 

interference in a residential installation. This equipment 

generates, uses and can radiate radio frequency ener-

gy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that 

interference will not occur in a particular installation. If 

this equipment does cause harmful interference to ra-

dio or television reception, which can be determined by 

turning the equipment off and on, the user is encour-

aged to try to correct the interference by one or more of 

the following measures: 

Reorient or relocate the receiving antenna. 

Increase the separation between the equipment and 

receiver. 

Connect the equipment into an outlet on a circuit differ-

ent from that to which the receiver is connected. 

Consult the dealer or an experienced radio/TV techni-

cian for help

Modifications not expressly approved by the manu-

facturer could void the user’s authority to operate the 
equipment under FCC rules.

Summary of Contents for 8320A









Reviews: