Edificio Genebre. Av. de Joan Carles I, 46-48
08908 L'Hospitalet de Llobregat. Barcelona (Spain)
[email protected] - www.genebre.es
GENEBRE S.A.
FECHA DE REVISIÓN: 19/01/2021 NUMERO DE REVISIÓN: 2
12
To adjust the open position to more than 90º:
Turn the wrench to anti-clockwise direction
– cams 2 and 4.
The cam 4 should press the lever of the micro switch a little before that the cam 2.
To adjust the open position to less than 90º:
Turn the wrench to clockwise direction
– cams 2 and 4.
The cam 4 should press the lever of the micro switch a little before that the cam 2.
9. Maintenance
These actuators are free maintenance, but when conditions are more severe, more
frequent inspections may be advisable.
•
Ensure valve actuator alignment.
•
Insure wiring is insulated, connected and terminated properly.
•
Insure all screws are present and tight.
•
Insure conduit connections are installed properly and are dry.
•
Verify declutch mechanism.
•
Visually inspect during open/close cycle.
9.1 Lubrication
GE Series electric actuator is a totally enclosed unit with a permanently lubricated gear
train. Once installed lubrication should not be required.
9.2 Cleanning
For external cleanning only use neutral detergent.
10. Trouble Shooting
The following instructions are offered for the most common difficulties encounter during
installation and start-up.
10.1 Actuator does not respond
•
Verify the line voltage (Power supply) to the actuator.
•
Check that the voltage matches the rating on the actuator nameplate.
