Edificio Genebre. Av. de Joan Carles I, 46-48
08908 L'Hospitalet de Llobregat. Barcelona (Spain)
[email protected] - www.genebre.es
GENEBRE S.A.
FECHA DE REVISIÓN: 16/03/2020 NUMERO DE REVISIÓN: 1
4
3. Safety Instructions
The scope of this manual is to enable a competent user to install, operate, adjust and
inspect a Digital Positioning System to GE quarter turn electric actuator. These
instructions must be observed, otherwise a safe operation of the actuator is no longer
warranted.
4. Transport and Storage
•
All
products are packed in sturdy packing. During transport measures should
be adopted in order to prevent impacts, hits.
•
Storage must be off the floor, covered with a sealed dust protector.
•
While commissioning, Genebre, S.A. recommend a visual inspection in order to
detect any anomaly caused during the transport, handling or during the
storage.
5. Pre-Installation Inspection
•
Verify the product nameplate to insure correct model number, before installation or
use.
•
Verify that the Kit is compounded from all parts (see Figure 1).
•
If there is any discrepancy, please contact with our local distributor, or Genebre,
S.A., to solve that discrepancy.
As electric device, during electrical operation certain parts inevitably carry
lethal voltages and currents (ELECTRICAL RISKS). Work on the electrical
system or equipment must only be carried out by a skilled electrician himself or
by specially instructed personnel, in accordance with the applicable electrical
engineering rules, health and safety Directives and any other
national legislation
applicable.
Under no circumstances should any modification or alteration be carried out
on the actuator as this could very well invalidate the conditions which the
device was designed.
