10
11
CHARGE
DISCHARGE
09
Quick Guide (Gold-mount Type)
* Do not use the battery (Main, D-Tap, USB) while charging.
If so, it may cause a charging error or damage the charger.
* Charge the battery to full before first use.
* When you charge this battery, Battery capacity LED gauge button will turn on indicating the capacity being charged.
* Lithium ion batteries have a slight self discharge, therefore it is recommended to charge prior to use.
* If you don’t use 20% bottom of capacity, its life time will become double.
* Camera's low voltage alarm is recommended to set 13V.
* Battery will stop at 11.4V to extend its life. (Reset it to re-use it by pushing and holding the gauge button for over 5 sec.)
* Microwave transmitters with 5W outputs or over should be kept as far away from the battery.
It may disrupt or stop supplying power.
* Be sure to remove the battery from the device after use.
If so, it will consume large standby power and over-discharge protection may be activated.
* USB is activated by pushing Battery capacity LED gauge button.
USB power will turn off automatically 30 minute after no use.
* Battery run time reduces when it is working below or above the recommended temperature range.
For more information
,
http://www.genenergy.co.kr
GEN ENERGY
GEN ENERGY
Li-ion Battery
MADE IN KOREA
ISO 9001 ISO 14001
SAMSUNG cell inside
Make sure of + - Polarity of D-Tap prior to plug-in
May explode when exposed to fire
Do not expose to extreme heat over 60ºC (140ºF)
Do not short the battery terminals
Opening unit will void warranty
Read instruction manual before use
Use recommended charger only
Keep dry and cool, best between 10ºC ~ 30ºC
Avoid heavy impacts
Recharge the battery to full before first use
MADE IN KOREA
CAUTION
CAUTION
Read throughly before use
Gold-mount lock
Main connector
Charging : 16.8V
Discharge : 12~16.8V 12A (sum of main, D-Tap, USB),
15A (15A model), 22A (22A model), 26A (26A model)
Negative
Do not short these two terminals
Make sure of polarity
Plug side
(male connector)
Receptacle side
(female connector)
Plug side
(male connector)
Receptacle side
(female connector)
Make sure of polarity
D-Tap 1
Charge : 16.8V
Discharge : 12~16.8V 7A max.
12A max.(15A, 22A, 26A models)
(sum of two D-Taps)
D-Tap 2
Charge : 16.8V
Discharge : 12~16.8V 7A max.
12A max.(15A, 22A, 26A models)
(sum of two D-Taps)
USB
Discharge : 5V, 2.3A max.
USB activated by pushing LED gauge button
(If no use for 30 min, it goes to sleep mode.)
LED gauge button
5 LEDs
LED On : 20 %
Blinking : 10%
Red blinking : to be charged (1% left)
※
Red On : Error (Push and hold this button for 5 second
s)=>Reset
* While discharging, if you push it three times, blue LED light disappears, push it three times again, light's back.
* If you push it, it will make the battery pack activated again from sleep mode.
(Battery pack goes to sleep mode 48 hours after no use)
