XT-1000
Page
9/19
During installation, take great care not to bend the probe tube,
and protect the float from shock and impact loads.
Installing a level sensor in areas exposed to a powerful external magnetic
field is not recommended because this could impair gauging.
The level sensor can also be fitted into the tank from underneath.
If the float is removed during installation, it must be slid back onto the
probe tube afterwards with the “TOP” marking oriented towards the
sensor head end, to enable correct measurements to be made.
4.1
Installation with screw-in unit
Figure 4: installation with screw-in unit
Removal of the float is necessary only if the float does not fit through the
installation opening in the tank. Otherwise, please proceed directly to
steps 3, 6 and, if applicable, 7.
Insert the level sensor into the tank (see Figure 4):
(1)
Loosen both set screws, remove collar (1) and remove float (2) from probe tube (3).
(2)
If necessary, slot screw-in unit (4) onto the probe tube.
(3)
Insert the level sensor into the tank, provide screw-in unit thread (4) with a suitable
sealing material, screw it in and tighten.
(4)
Slide float (2) back onto probe tube (3).
1
2
3
4
5
Summary of Contents for XT-1000
Page 2: ...Page 2 19 XT 1000 ...
