Assembly Instructions
x1
x4
x4
x4
x1
Package Contents
Ensure the four clips on the bottom
of the fabric of the inflatable (A) are
attached to the plastic legs on the
base of the intlatable.
Ensure that the air intake on the
inflatable (A) unit is clear of fabric and
other obstructions and that the zipper
is fully closed. Some inflatables have
more than one zipper.
Turn the inflatable (A) upright and insert
four base stakes (B) through the holes
of the plastic legs into the ground.
Plug in the inflatable (A) into an outlet
or other power source to inflate.
Once fully inflated, clip the nylon tethers
(C) to each of the attached nylon loops
on the side of the inflatable (A).
Drive the stakes (D) into ground at a
45-degree angle.
A
B
1
For maximum stability bring tether down
to a 45-degree angle from the inflatable
as shown in the illustration. In order to
achieve this you may need to wrap the
excess tether around the top of the stake.
2
3
4
5
7
8
A
A
A
A
B
C
A
D
45°
D
E
Visit
WWW.GEMMY.COM
for more information.
©2019 GEMMY INDUSTRIES CORP.
117 WRANGLER DRIVE. SUITE 100
COPPELL, TX 75019 U.S.A.
1 (800) 274-6717
MADE IN CHINA / PRINTED IN CHINA
Using the loop at the end of the tether
(C), fasten the tehters to the tether
stakes(D)
.
6
D
C
Do’s and Don’ts
1. Do check your inflatable daily and adjust
to stand up straight.
2. Do not attempt to operate your inflatable
in unusually strong winds.(see caution)
3. Do not unplug by pulling on cord.
For faster deflation, unzip zipper after
unplugging plug.
9
C
1.) For temporary (90 days max) installation and use only. 2.) This is an
electric product — not a toy! To avoid risk of fire, burns, personal injury
and electric shock it should not be played with or placed where small
children can reach it. 3.) Use only 125-volt fuse, 5 amp. max. 4.) To
prevent electric shock, match wide blade of plug to wide slot, fully insert.
5.) Disconnect power before replacing the fuse. 6.) To reduce the risk of
fire or electric shock, do not attempt to replace lamps or modify wiring or
product. 7) Do not place near standing areas of water, such as ponds
and pools
.
8.) To reduce the likelihood of excessive heat and possible
damage, use only decorative l amp accessories packaged w ith this
product or marked for use with this product.
CAUTION:
