User’s Manual
© Nippon Telesoft Co., Ltd. March 2003.
2. Loading Continuous Feed Paper
Load the paper into the feeder.
The feeder attaches to each perforation opening on the left and right sides of the paper.
When changing the paper, move the feeder to the appropriate partition after releasing the
feeder lock. For 9.5-inch width paper, slide it to the inner partition, for 11-inch width
paper, slide it to the outer partition.
The paper will load onto the holes of the feeder guide. If paper its tip is bent, it may cause
a paper jam when insertion of the paper.
【
Caution
】
:Technique for Releasing the Lock
The paper feeder is fitted to rounded and square rails. There is a lever attached to the
outside of the paper feeder. If you push this lever upwards, the lock will be released; if you
return it to the down position, it will be locked again.
Turn on the electrical power and press the Load Paper Switch (forward or back).
Then the paper will advance to the position selected for printing.
【
Caution
】
:When changing continuous feed paper, be sure to turn off the
electrical power, turn the paper feed handle and remove the paper.
3. Type of ink ribbon cassette that can be used
An exclusive type of ink ribbon cassette is used. Please order them from your sales agent.
9
