Use the face panel located rotary
CUE VOLUME CONTROL
(13) to adjust the
CUE
volume without changing the overall mix.
By turning the face panel located
CUE 1/2 ROTARY CONTROL
(14) counter clockwise you will be able to choose the channel
you wish to monitor.
5.
CROSS FADER SECTION:
The
CROSS FADER
(16) allows
you to mix from one source to another. The
CROSS FADER
(16)
in your unit is removable and if the need arises can be easily
replaced. Also available are our
RG-45
(
RAIL GLIDE™
)
DUAL-
RAIL CROSS FADER
and
RG-45Pro (Rail Glide PRO)
The
RG-45
features, a stiffer feel and smoother curve specially made
for mixing, while the
RG-45Pro
is specially designed for scratch-
ing, with a smoother feel and a special scratch-oriented curve.
Just purchase one from your
Gemini
dealer and follow the
instructions:
NOTE: DO NOT APPLY PRESSURE WHILE USING THE CROSS FADER (16).
LIGHTLY GLIDE THE CROSSFADER BACK AND FORTH. PRESSING DOWN
ON THE CONTROLS CAN BEND CONTACTS AND CAUSE A LOSS OF
SOUND.
6.
OUTPUT SELECTION CONTROL:
Once you are comfort-
able with the sound level of your music you may adjust the vol-
ume with the
MASTER
(11) rotary control.
7.
MIC SECTION:
Plug your main
MIC
into the
MIC 1/4"
input
(3) located on the rear panel.
8
.”Ipod Friendly” cable:
To connect your Ipod or other Digital
Media Player, use the included Ipod cable. Connect the 1/8’’ end
of the cable to the headphone or line out jack of your player, and
connect the RCA end to the line input (7) of your mixer.
INPUTS:
Phono..................................................................3 mV, 47 KOhm
Line.................................................................150 mV, 27 KOhm
MIC…………..........……….................1.5 mV, 1 KOhm Balanced
OUTPUTS:
Max.................................................................20V Peak-to-Peak
GENERAL:
Frequency Response................................20Hz - 20KHz +/- 2 dB
Distortion.........................................................................< 0.02%
S/N Ratio.........................................................Better Than 80 dB
Headphone Impedance...................................................16 Ohm
Power Source.....................................AC 15V 500mA
Dimensiones....................................................6.5" x 3.3" x 10"
…………………………………………….....(165 x 84 x 254 mm)
Weight...........................................................3.3 lbs (1.5kg)
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTIFICATION FOR
IMPROVEMENT.
SPECIFICATIONS:
REPLACEABLE CROSS FADER
1. UNSCREW THE OUTSIDE FACE PLATE SCREWS ON THE LOWER HALF OF
THE MIXER. REMOVE THE FADER CAPS AND FACE PLATE.
2.UNSCREW THE FADER (B)
SCREWS. DO NOT TOUCH INSIDE
SCREWS
(C).
CAREFULLY
REMOVE OLD CROSS FADER AND
UNPLUG CABLE (D).
3. PLUG IN THE NEW CROSS
FADER INTO CABLE (D) AND
PLACE BACK INTO MIXER.
4. SCREW THE CROSS FADER TO
MIXER WITH THE FADER PLATE
SCREWS (B).
5. REPLACE THE LOWER HALF
FACE PLATE AND SCREW TO THE
MIXER.
