25
P R O G R A M M I N G ( O P T I O N A L )
6. Continuing, set the cursor to the
user code with the
A
button and enter
the new User Code using the number but-
tons. Press
G0
for any blank loca-
tions until you end up back to the flashing
“UP”.
7. Press the
J
button to save the code
in memory.
Repeat Steps 4 through 7 for each
user.
Note:
To void a code, simply enter the
2-digit user number, then press the
J
but-
ton.
Programming Example
Example. Program User 3's Code as
“3784”.
1. Select the Program Mode as follows:
(a) Enter your code, then press the
A
button.
(b) Answer NO (
F
button) repeatedly until “17” is displayed, then press the YES (
E
button). The display will scroll “P”
followed by 4 digits (for installer's use), then “UP” (indicating user programming) and the lights will continue to flash.
2. Press the
A
button then
03
to enter User No. 3, then press the
A
button again followed by
3784 G0 G0
to program the code.
Programming User Codes
To Program User Codes
1. Enter program code, then press
the
A
button.
2. Press NO (
F
) until “17”
displays, then press YES
(
E
).
3. When “UP” displays with a
flashing light, use the number
buttons to enter a 2-digit user
number followed by a user code
of up to 6 digits.
4. Press the
J
button to save.
5. Repeat steps 3 & 4 to enter all
user codes.
6. Press the
C
button to exit.
NOTE:
Press
G 0
button to clear character at cursor.
To continue press
E
or
F
button.
GEM-RP3DGTL.pub
page 25
Wednesday, August 18, 1999 14:03
