9.0 - PIN CODE CUSTOMIZATION
Here below is a step-by-step example showing how to customize the factory
PIN code. In this case the selected PIN code is
.
2-3-4-1
Ground the BROWN-GREEN wire.
Disconnect the BROWN-GREEN
wire.
Open the seat (if protected by a
contact switch).
Close the seat if previously opened.
Turn ignition key “ON”
.
The status LED will light up for approx.1 sec.
While the LED is ON, simultaneously press both remote control buttons.
2 Bops will sound and the LED will power ON steady.
D
.
isarm the alarm system
Key “ON”
1 sec.
Bop
Bop
Steady
ON
GROUND
GROUND
BROWN-GREEN
BROWN-GREEN
PAGE 13
PAGE 14
Bop
Bop
Beep
Simultaneously press both
.
remote control buttons.
The LED will turn OFF
LED
OFF
LED
OFF
Turn ignition key “OFF”
.
After 4 sec., the LED will flash 9 times in sequence.
Count the number of flashes and cycle ignition key ON and OFF when the
number of flashes equals that of the new PIN code 1st digit.
Repeat the above steps to enter the last 2 digits.
When the 4th digit is entered, the system automatically exits the procedure.
2 Bops and 1 Beep will confirm the code has been entered successfully.
After
.
4 sec.,
.
2nd digit
there will be another sequence of LED flashes
Repeat the above step to enter the
Key
“OFF”
Key
“ON”
Key
“ON”
Key
“OFF”
Key
“OFF”
Last
digit
LED
OFF
Key
“ON”
Key
“OFF”
