18.0 - ACCESSORIES
18.1 - STATUS LED
Since the LED warning light serves as both a system status indicator and a
visual deterrent it
Always check the rear clearance before drilling:
• Drill a
must be installed where it can readily be seen.
ø 10mm hole and insert the LED holder.
• Gently press the LED holder until it clicks into place.
• Connect the LED Black 2-pin connector to the alarm Black 2-pin connector.
• Bundle up and tie down any excess wires.
18.2 - CONTACT SWITCH (OPTIONAL)
A contact switch can be fitted to protect the seat or topcase. It must be installed
in such a way as to detect the opening of the seat/topcase without being
accessible from the outside.
The trigger threshold must be carefully set to avoid false alarms.
Do not ground the switch terminal to the vehicle chassis as it might not be earth
grounded. Connect to a wire that provides continuous ground such as the turn
indicator lamp negative lead.
NB:
If no contact switch is fitted, the GREEN/BROWN wire will remain free for
other possible uses such as programming the alarm or learning new devices
.
PAGE 19
PAGE 20
Attach to cut end of key switch wire
Attach to cut end of main wiring harness.
.
Connect to a permanent negative connection
(do not connect to vehicle chassis
Connect to the cable end which, if grounded, will kill
the engine.
).
19.0 - PINOUT TABLE
Wire function
Wire color
Pos.
- 1 -
- 2 -
- 3 -
- 4 -
- 5 -
- 6 -
- 7 -
- 8 -
- 9 -
- 10 -
- 11 -
- 12 -
- 13 -
- 14 -
- 15 -
- 16 -
---
Brown
White-Violet
Green-Brown
---
---
Yellow
Black
---
Grey
White
White-Grey
Orange
Red
Orange
Black
N/A
Power supply earth ground
Turn indicators (12V, 6A max.)
Positive supply
Turn indicators (12V, 6A max.)
LEARN button / Anti-hijack
N/A
N/A
Ignition
LED
N/A
Contact switch input
Immobilizer (N.C.)
Immobilizer (Com.)
Immobilizer (N.O.)
Antenna
negative output
IMMOBILIZER - wire joint
IMMOBILIZER - grounded wire
Wire color
Wire color
White
Grey
White
White/Grey
Connections
Connections
CAUTION
Alarms are supplied without wiring harnesses. A wide range of specific pin-
to-pin wiring harnesses is available for the most common motorbikes.
KITCA 417N17.
The following tables refer to the generic wiring harness
18.3 - ANTI-HIJACK BUTTON (OPTIONAL)
Connect the anti-hijack button to the White-Violet wire. The anti-hijack will
trigger when a negative signal is detected.
ATTENTION
!
This alarm system is intended for 12V turn indicators.
sure the flashers are powered by a
12V signal.
Before you do any electrical work, make
