Slide the foot onto the tab on the
underside of the nose of the saw.
The foot comes with a phillips head
screw and nut. Put them on loosely.
Snug the screw down to secure it in
place.
Slide the foot down until the space
between it and the base of the saw is
slightly larger than the thickness of
the material being cut.
Rest the foot on the material when
cutting. Do not hold it above the
material.
Note: When cutting, the sponge will
give 5-10min. of use then the cut will
start to show powder. Do Not Keep
Cutting! Add water by squirt bottle
through the hole the blade goes
through or re-soak the sponge.
Clean the sponge often especially
after use.
Page 14