3DP-i3V2-01 - 3D printer for ABS/PLA filament
3DP-i3V2-01 - 3D printer for ABS/PLA filament
CONSTRUCT AND CONNECT
Remove tape from each corner of the Heated Print
Bed. Squeeze each corner of the printing bed, and
tighten each wing nut to reduce the distance between
plates to a minimum. Wipe the top of the Heated Print
Bed with a clean, lint-free cloth to ensure there are no
dust particles or other objects on the surface.
Turn on the 3D Printer. Once initialised, press the dial
to enter the Main Menu, navigate
Position > Home
All.
The 3D printer extruder nozzle will move to the
‘Home’ position in the front left corner of the Heated
Print Bed. Turn off the 3D printer.
NOTE:
Immediately turn off the machine if any of the
motors are jamming or forcing against the frame.
With the printer powered off, rotate the wing nut
under the corner of the Heated Print Bed to raise to
a distance of 0.1mm between nozzle and the surface
of the Heated Print Bed. Test the distance by sliding
an A4 sheet of paper between the extruder nozzle
and the Heated Print Bed. There should be very slight
friction between the paper and the nozzle but the
paper should still slide freely.
Push the extruder to the far right and repeat the
process. Push the Heated Print Bed and adjust the
back corners. Finally, move the extruder and Heated
Print Bed to the centre and test. Check all points
again before proceeding to the next step.
NOTE:
Ensure bed movement is not restricted by any
cabling, all cables should be placed under the base
IMPORTANT NOTE:
Levelling the bed is an extremely important step. If it is not done correctly every time, your
prints will fail.
LEVELLING THE PRINT BED
