3.1.4-Battery installation.
Once the battery is perfectly lined-
up, it is necessary to install special
supports to hold up the weight of the
battery and the water that follows in
it.
When the proper level and height
have been achieved, the screw that
supports the clamp must be
tightened using a spanner.
In order to avoid that pulses and
vibrations could damage or break the
batteries when the tubes are being
installed, other kind of supports are
also available.
IMPORTANT NOTE:
Avoid the fixing system that blocks
the normal dilation of materials.
If you have any doubt,
4-
STARTING
Before filling filters sand or other filtration elements, it is
advisable to check the internal collectors to make sure
that they have not been damaged during transport or
installation. Afterwards, fill the filters and the water
installation and make an hydraulic test. Thus, you will
make sure that there is no leak and that equipment
works properly.
Then stop the pumps, open each fi
lter’s lid (the filter
must not be emptied without opening the lid, as it could
collapse) and empty half the water that each filters
contains.
Then, start filling the filter with sand or other filtration
elements, taking into account that first of all you must
put gravel up to the collector arms (10 cm. approx).
This must be done very carefully in order to avoid any
damage in the lower components of the filter. When the
filter is being filled with sand, this must be carefully
spread over the surface.
Once the filter is full with the filtration elements clean
the lid and the inner part of the manhole. This will
prevent any debris and particles of sand affecting the
seal of the joint. PLease follw the filling order of the
bottom filter first, and top filter second for dual stack
filters.
No
Description
1
Filter lid
2
Filter lid gasket
3
Air purge
4
Air purge o-ring
5
Screw cap
6
Inox Nut
7
Washer Inox
Put the seal in the lid; then introduce the lid in the
manhole, screws must be possitioned according to screw
gaps on the lid to fix with nuts, leaving it leveled and
centered.
Washers and nuts must be put on screws and tightened.
1
2
3
4
5
6
7
