Cinterion
®
EHS6 AT Command Set
12.12 AT+CNMI
EHS6_ATC_V03.001
15/12/3
Confidential / Released
Page 340 of 513
2
SMS-DELIVERs, except class 2 messages and messages in the message
waiting indication group (store message) are routed directly to the TE via URC.
3
Class 0 and 3 SMS-DELIVERs are routed directly to the TE via URCs defined
for
=2. Messages of other data coding schemes result in indication as
=1.
Rules for storing received CBMs depend on the relevant data coding method (refer to 3GPP TS 23.038
),
the setting of Select CBM Types (
) and this value:
[0]
(&F)(P)
No CBM indications are routed to the TE.
1
If CBM is stored into ME, indication of the memory location is routed to the TE.
2
New CBMs are routed directly to the TE via URC.
3
Class 3 CBMs are routed directly to TE using URC.
[0]
(&F)(P)
No SMS-STATUS-REPORTs are routed to the TE.
1
SMS-STATUS-REPORTs are routed to the TE via URC.
2
If SMS-STATUS-REPORT is routed into ME, indication of the memory location
is routed to the TE via URC.
[0]
(&F)(P)
ME's buffer of SMS related URCs is flushed to the TE when
changes
from 0 to 1, 2 or 3.
1
ME's buffer of SMS related URCs is cleared when
changes from 0 to
1, 2 or 3.
Integer type; value in the range of location numbers supported by the associated memory
Notes
• Parameters
=2,3 and
=1 are only available with GSM phase 2+ (see
=1). Incoming SMs
or Status Reports have to be acknowledged with
=0 when using these phase 2+ parameters.
If either a SM or a Status Report is not acknowledged,
=2,3 and
set to zero as specified for
• Please note that parameters omitted in the write
command will be set to zero.
<bm>
(num)(&V)(&W)
<ds>
(num)(&V)(&W)
<bfr>
(num)(&V)(&W)
<index>
(num)
