Rev. 00 03/22
OptiFeed BigBag (FPS16)
Operation
•
37
Color change
When a color change takes place, the individual components of the
equipment must be cleaned carefully. All powder particles of the former
color must be removed during this process!
A color change with a partially emptied large container must take
place in same way. In this case, it's important that the partially
emptied container is well locked for storage.
The following describes an 'extreme' color change (light to dark).
1.
Empty the powder hose by removing the fluidizing/suction unit from
the powder box when the conveying is activated
2.
End powder feed
3.
Stop vibration of the powder box
4.
Activate cleaning mode (see OptiFeed 4.0 operating manual)
– The automated cleaning procedure is started
5.
Clean the entire equipment with compressed air
• Connect powder hose to the fluidizing/suction unit
• Prepare the equipment with new powder for start-up
Summary of Contents for FPS16
