Rev. 01 08/20
OptiStar All-in-One (CG22-C)
Operation
39
Setting powder output and powder cloud
The powder output depends on the selected powder output (in %), and
the powder cloud on the selected total air volume.
As a factory default value, a powder rate of 50% and a total air
volume of 4 Nm³/h are recommended.
– If values are entered that the gun control unit cannot implement,
then the operator is informed of this by a blinking in the relevant
display and a temporary error message!
Setting the total air volume
1.
Adjust the total air volume
according to the corresponding
coating requests
correct powder cloud
too little total air
Setting the powder output
1.
Adjust the powder output volume
(e.g. according to the desired
coating thickness)
much powder
little powder
– Factory default setting of 50% is recommended for initial
operation. The total air volume is thereby kept constant
automatically by the control unit.
To achieve maximum efficiency, we recommend avoided an
overly high powder volume where possible!
2.
Check fluidization of the powder in the powder container
3.
Switch the gun on and visually check the powder output
Summary of Contents for CG22-C
