III. Program Instruction:
Enter Program Mode:
1. Enter the master code twice (Factory master is
「
12345
」
)
→
2 beeps and the Yellow LED will light up.
→
you are now in the "programming mode".
2.
Note:
After 60 seconds if you have not entered any codes or data, the system will
automatically exit from the programming mode. After 6 wrong attempts at the master
code the lockout facility will operate.
Exiting from the program mode:
1. Press
「
#
」
to exit from the programming mode.
2.
Note:
After 60 seconds if you have not entered any codes or data, the system will
automatically exit from the programming mode. After 6 wrong attempts at the master
code the lockout facility will operate.
To Enter a User Code
：
Enter the Programming mode
1. Enter the slot position code
「＊
01~
＊
10
」
→
?????
（
user code 5 digit
）
→
（
beep
）
→
enrolled
→
Press # to exit from the programming mode, or program other operating.
2.
Note:
The codes"00000","12345" or master code are not be used for PIN code.
To Program Relocking Timer
（
relay
）：
Enter the Programming mode
A. Press
「＊
20
」
Followed by the number of seconds the relay should open
→
「
05
」
=5 seconds
（
01 ~99 = seconds
）
→
（
beep
）
→
enrolled
→
Press
「
#
」
to exit from
the programming mode, or program other operating.
B. Enter
「
00
」
Sets the relay to latching mode.
(Correct code entered opens the relay,
and the relay stays open until the correct code is entered again).
To Delete a User Code
：
Enter the Programming mode
→
Press the slot position code of your choice to delete
(example "06")
→
Press
「＊
06
」
→
「
00000
」
→
（
beep
）
→
delete
→
Press
「
#
」
to exit
from the programming mode, or programming other operating.
To Change the Master codes:
Enter the Programming mode, Enter
「＊
00
」
Followed by the new 5 digit master code
→
（
beep
）
→
enrolled
→
Enter
「
#
」
to exit from the programming mode, or program other
operating.
IV. Wiring diagram:
1
2
3
V
B(White)
P(White)
N.C.(Blue)
Com.(Green)
N.O.(Yellow)
Power in(Red)
Power in(Red)
1
2
3
12Vdc
Power
Supply
Push Button
Relay
Buzzer
Master Code
resetting to
Factory Code
"12345"
FAIL-SAFE LOCKING
DEVICE
Varistor
Contact door reed switch
(Pink)
This reed switch is used
to reset the re-locking time
to 0 second when the door is moved.
(Using N.O. contact in case of door closed,
changeover to N.C. When door is moved)
Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG10-5C Ver. B Publish:2009.06.15 Page: 2/ 3
