Watchdog 100 Instruction Manual
52
© 2017 Geist
GM1118 Watchdog 100 Instruction Manual
Figure 3-35 SNMP Traps Configuration Page
Traps allows you to define the IP addresses and SNMP types that you wish the traps to
be sent to.
Figure 3-36 SNMP Traps/Types IP Configuration Page
To configure a trap destination:
1. Locate the
Traps
section of the SNMP page, and click on the Add icon.
2. Enter the IP Address which the trap should be sent to in the
Host
field, change the
Port
number if required, select the trap
Version
to be used (v1, v2c, or v3), and click
Save
.
A test trap may be sent by clicking on the Test icon next to the Host IP address. Trap
settings can also be updated/changed by clicking the Modify icon next to the Host IP
address.
Syslog
Syslog data can be captured remotely but must first be setup and enabled via the Syslog
page.
NOTE
This function is primarily used for diagnostic purposes, and
should normally be left Disabled unless advised to enable it by
Geist technical support for troubleshooting a specific issue.
