2 System Controls
The Garnet has three buttons on its front panel as shown here. Many of the measuring modes are
selected automatically and an explanation of these modes and manually selected functions are detailed
in the following sections. The diagram below identifies these controls along with the other major
components found on the Garnet.
2.1 Switching On
The button marked (
) should be pressed for a period of approximately 2 seconds, this will run a
system test and then start the gauge operating.
2.2 Switching Off
Pressing both buttons (
+
) simultaneously for 5 seconds will switch off the gauge. Alternatively,
if the auto ‘Power Off’ option has been enabled, then the gauge will automatically switch off after a
preset time of inactivity. This is detailed in the ‘
Software Menus’
section of the manual..
2.3 Control Buttons
These two buttons are marked (
) and (
) and are used to operate the Garnet. Their functions
change depending on the current mode, but in most cases contextual help is provided to aid the user.
Chapter
Carry Handle
Groove Paddle
Measuring Feet
Charging Socket
Gauge Paddle Lock
Gauge Paddle
LCD Display & Controls
GAD04DOC820Ver9 - en.docx
6
