GEIGER SOLIDline GU45 Series, Original Assembly And Operating Instructions, Page: 7 / 12

7
www.geiger.de
EN
EN
8. Setting of the end stops
I
WARNING: do not press the setting button when the rolling shutter
has reached the upper or lower end position ; this could damage the
mechanism.
I
WARNING: activate key at least one tube rotation before reaching the
end positions
Note:
f
You can begin with the upper or lower end position (Here‘s one example beginning
with the upper end position)
f
Setting range: max. 38 rotations between the end positions
f
The button pops out during process (and not when changing the direction). The
adjustment is completed after half a rotation after changing direction.
Move the rolling shutter at least 300 mm below the required end position.
Press the setting button.
Move up the rolling shutter to the required end position.
Once the required position is reached, move down the rolling shutter about
3 seconds (one tube rotation). The upper end stop is thus adjusted.
Stop the rolling shutter and press again the setting button.
Move down the rolling shutter to the required end position.
Once the required position is reached, move up the rolling shutter about
5 seconds (one tube rotation). The lower end stop is thus adjusted.
NOTE: If you want to readjust the end position, please move the rolling shutter in the
opposite direction about 5 seconds (one tube rotation) before repeating the operation.
I
There is no need to first delete the end stops (memorised) if you wish
to modify them.
I
It is possible to adjust an end stop without modifying the other ones.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
6.
7.
1.