GEIGER PRO.TECline Spindle GB45 Series, Original Assembly And Operating Instructions, Page: 7 / 12

7
www.geiger.de
EN
EN
Changing the setting range
Irrespective of the assignment of the setting screws:
• Rotation in minus direction reduces the setting range
• Rotation in plus direction increases the setting range
Setting the upper end position
Press the UP key on the control switch until the hanging
stops automatically.
Depending on the installation situation, turn the
corresponding setting screw with UP key pressed down in
PLUS direction until the selected upper end position is
reached.
If the upper end position is overrun (the motor
switches off too late):
• Press the DOWN key until the hanging is below the selected end position.
• Turn the setting screw a few turns in MINUS direction and repeat the procedure described
above again.
Setting the lower end position
Press the DOWN key on the control switch until the
hanging stops automatically.
Depending on the installation situation, turn the
corresponding setting screw with DOWN key pressed
down in PLUS direction until the selected lower end
position is reached.
If the lower end position is overrun (the motor
switches off too late):
• Press the UP key until the hanging is above the selected end position.
• Turn the setting screw a few turns in MINUS direction and repeat the procedure described
above again.