GEIGER GJ5606-DuoDrive, Original Assembly And Operating Instructions, Page: 8 / 12

8
Gerhard Geiger GmbH & Co. KG | 100W1591 1118 V000 en
EN
EN
Adjustment of upper end position
1. Move the Venetian blind approx. 300 mm below the required end position.
2. Press the
black adjustment button.
3. Move up the Venetian blind to the required end position.
4. Move down the Venetian blind about 6 seconds, until the
black adjustment
button jumps back audibly (click).
Now the upper end position is adjusted.
Adjustment of lower end position
1. Move the Venetian blind approx. 300 mm above the required end position.
2. Press the
white adjustment button.
3. Move down the Venetian blind to the required end position.
4. Move up the Venetian blind about 6 seconds until the
white
adjustment button
jumps back audibly (click).
Now the lower end position is adjusted.
9. What to do if…
Problem Solution
Motor does not run. • Motor not plugged in.
Please check the plug connection.
• Check connecting cable for possible
damage.
• Check the mains voltage and allow the
cause of the voltage break down to be
tested by a specialist
electrician.
Instead of in the upwards direction, motor
runs downwards.
• The control leads are interchanged.
Exchange black/brown control leads.
Motor only runs in one
direction.
• Motor in the end position.
Run motor in the opposite direction.
Readjust teh end positions, if necessary.
After running several times,
the motor breaks down and
no longer responds.
• The motor became too hot and has
switched off.
Try it again after a cooling time of about
15 min.
The blind is in the upper end position,
actuates the limit stop switch and can no
longer move downward.
• The motor has been installed upside down
or the lower end stop has been overrun
and the straps are wound up the wrong
way.
Restore free motion of the limit stop switch.
Re-adjust the end positions
10. Maintenance
The drive is maintenance-free.