STORAGE
If the Telescopic Forklift will not be operated for a
long period of time, prepare and store it using the pro-
cedures as follows.
Before Storage
Perform the following prior to placing the machine in
storage:
1
Wash off the entire machine.
2. Lubricate all grease fittings as described in the
Lubrication chapter of this manual.
3. Change engine oil as outlined in the SERVICE &
STORAGE chapter of this manual.
4. Apply grease to all exposed hydraulic cylinder rod
areas.
5. Disconnect the battery cable clamps and cover the
battery or remove the battery from the machine and
store it separately.
6. If the ambient temperature (at anytime during the
storage period) is expected to drop below freezing,
make sure the engine coolant is either completely
drained from the radiator and engine block or that the
amount of anti-freeze in it is adequate to keep the
coolant from freezing. Refer to the separate engine
manual provided for anti-freeze recommendations and
quantities.
908424/AP500
54
PRINTED IN U.S.A.
During Storage
1. About once each month, connect the battery and
check all fluid levels to make sure they are at the prop-
er level before starting the engine.
2. Start the engine and allow it to run until it warms
up and then move the machine a short distance to help
relubricate the internal parts. Run the engine until the
battery has a chance to recharge and then shut it off.
IMPORTANT:
If it is desired to operate the
hydraulic cylinders at this time, BE SURE to wipe
the protective grease (and any adhering dirt) from
the cylinder rods prior to starting the engine. After
operating, BE SURE to recoat the cylinder rods
with grease if the machine is to be returned to
storage.
After Storage
After removing the machine from storage and
BEFORE operating it, perform the following:
1. Change engine oil and filter to remove condensa-
tion or other residuals.
2. Wipe off grease from cylinder rods.
3. Lubricate ALL grease fittings.
4. Review and refamiliarize yourself with all safety
precautions as outlined in the SAFETY chapter of this
manual.
5. Follow the starting and warm-up procedures as
outlined in the OPERATION & ADJUSTMENTS
chapter of this manual.
Summary of Contents for Dynalift 552
