11
with too much paper in the feeder. Should a paper jam occur, remove all paper from the feeder
and wait until the device has finished its automatic cleaning process and has stopped operat-
ing. Only insert a maximum of 12 sheets A4, 70 g/m² into the feeder.
‘fWD‘
If you place a narrow piece of paper (< 10 cm) into the feeder sideways, then the photoe-
lectric barrier may not detect it and thus not start the device automatically. In that case,
press and hold the button: ‘FWD‘, until the paper has been drawn in completely.
‘rEv‘
By pressing the button: ‘REV‘, you can initiate the reverse operation of the cutting
mechanism in case of a paper jam.
When the sensor detects that the waste paper container is full, the device will stop automati-
cally, and the viewing window in the waste paper container will be illuminated in blue. First
remove all paper from the feeder, and then empty the waste paper container. Please note the
instructions in the section: ‘Maintenance‘!
Important note:
The device will switch off automatically if the motor temperature increases too much. The
LED ‘status‘ will light up red (overheating) and signals that the overheat protection of the de-
vice has been activated. If that is the case, the device will not react when you press the button
‘rEv‘ or ‘fWD‘. once the motor has cooled down sufficiently, the device will switch back into
normal operating mode, and the LED ‘status‘ will light up green.
maINTENaNcE
Important:
pull the mains power plug from the wall socket before carrying out any maintenance tasks on
the file shredder!
When the waste paper container is full, shredded material can be pushed upwards into the cut-
ting mechanism. Make sure to empty the waste paper container before it is filled completely.
Clean the exterior of the file shredder with a moist cloth. Ensure that the cloth is kept well
away from the paper feed. This cleaning step is suitable only for the exterior of the device.
The exterior of the device is made of plastic. That is why no solvents like benzene or benzole, or
any organic solvents (e.g. thinner) may be used to clean the exterior of the device. Never clean
the device with a stain remover - this may cause the casing to fade, crack, dissolve or graze.
caution:
make sure that no water gets into the device while cleaning the casing.
Manual_Office_X12.indd 11
15.07.10 15:40
Summary of Contents for OFFICE X12
