Connect your source to the VGA Audio Extender sender unit using the included
VGA Cable.
Connect your audio and mic source to the VGA Audio Extender sender using the
included audio cable (mic cable sold separately).
Connect your display to the VGA Audio Extender receiver unit using a VGA Cable.
Connect the audio on your display or audio receiver to the VGA Audio Extender
receiver unit using the included audio cable. At this point you can also connect your
mic to the receiver.
Connect your CAT-5 cable between the sender and the receiver.
Plug the 5V power supply into the VGA Audio Extender sender and receiver unit.
Turn your display on fi rst, then your source and you should now have picture and
sound.
INSTALLATION INSTRUCTIONS
1.
2.
3.
4.
5.
6.
7.
4
If you do not get a picture, make sure you have everything connected correctly and that
both LED lights on the sender and receiver units should be green. If your LED lights are
red, verify that everything is connected correctly. First, make sure you check the VGA
cable, connecting from your source to the sender, is attached properly and that your
CAT-5 cable, connecting your sender and receiver, is also connected properly. If you
continue to see a red light after you have verifi ed that all the cables have been connect-
ed correctly, then please contact technical support.
LED INDICATORS
BRIGHTNESS AND FOCUS TRIM PODS
If your picture is too dark or if you see a “ghosting” effect on your display, then the trim
pods will help correct this problem. If your picture is too dark then the brightness trim
pod will help brighten up your display. If your picture has a “ghosting” effect, Then the
focus trim pod will help sharpen up your picture.
