8
Why would I need to change the remote channel?
In some instances, the 2x2 Switcher for HDMI 1.3 may use IR codes that confl ict with
other IR remote control devices. The unit may switch inputs when another brand IR
remote control is used or the RMT-2IR may cause other brand IR controlled devices
to behave unexpectedly.
I am experiencing the issues listed above. What do I do?
In these cases it is recommended to change the IR channel that the RMT-2IR
remote control and the 2x2 Switcher for HDMI 1.3 use. The IR channel is confi gured
independently on the RMT-2IR remote control and the 2x2 Switcher for HDMI 1.3 but
the channel selection must match on both units for proper operation.
How Do I change the Remote Channel?
There are service DIP switches on the RMT-2IR remote control for channel
confi guration. The 2x2 Switcher for HDMI 1.3 uses a combination of buttons on
the rear panel to confi gure the IR channel. There are 4 channels available for use.
Please use the diagram below and information on the next page to locate and
change the IR channel to one that is not the default. Remember that the IR channel
must match on both the unit and remote control for successful operation.
2 DIP switch bank for IR channel confi guration.
RMT-2IR Remote Control
Remote Channel 1:
Default
1 2
Remote Channel 2:
1 2
Remote Channel 3:
1 2
Remote Channel 4:
1 2
Remove the battery cover on the rear side of the RMT-2IR remote control
to expose the DIP switches.
IR CHANNEL CONFIGURATION
