BACK PANEL DESCRIPTIONS
4
1
2
3
4
5
6
7
8
9
24VDC -
Connect to 12-24VDC power supply.
Remote -
2 wire serial remote control
RMT4 -
RJ45 connector connects to the ex•tend•it RMT-4 remote control. Each
RMT-4 controls one of the outputs by switching to one of the inputs.
USB In -
USB input from each source (computer).
USB Out -
Connects to USB devices for the output.
HPD/5V -
When switches 1,2,3, & 4 are in the UP position, it will make the HPD pin
(Hot Plug Detect pin 16) active. When the second set of 1,2,3, & 4 switches under
the
+5v
heading are UP, it will 5v to the DVI cable (pin 14). These switches
should be in the DOWN position unless you are using a fi ber optic based DVI cable
and the source is not sup5v power on pin 14.
Caution:
Setting the
+5v
dip switches in the ON position when a DVI source is
already outp5v may harm your DVI source.
DVI Input -
Connects to computers or the HDTV source
E Select -
EDGE select is set by dip switches from the back panel. For normal
operation, all four EDGE switches should be set to UP.
DVI Out -
Connects to DVI displays
