15
CONNECTING AND OPERATING THE
4X CAT6 EXTENDER FOR HDMI
Routing Sources using the Optional RMT-4-IR Remote Unit
(Matrix Mode)
There are a total of 4 buttons on the RMT-4-IR remote, which represent each of
the 4 buttons on the Receiver unit.
Example 1
:
Route the source connected to HDMI In 3 (from the 4x4 Matrix) on
the Sender unit to the display connected to HDMI Out 2.
Point the Remote at the Receiver unit connected to Display 2, then press button
3 on the RMT-4-IR.
Table of IR Remote Commands
for the Optional RMT-4-IR Remote Unit
RMT-4-IR Button
Source
1
1
2
2
3
3
4
4
The RMT-4-IR remote control unit will allow the selection of any input (source) on
the 4x4 Matrix unit can be will be routed to any of four Receiver units. Use the
information in the table above when routing the desired input to a display.
