Geepas GCM41504UK, User Manual

Page: 5 / 11

8
9
1. Set the current time by pressing HOUR and MINUTE
button repetitively, that is 8:10.
Note: The time cycle is 24 hours.
2. Press P R O G R A M button one time, the indicator of
ON/OFF button will illuminates in green and flash.(means
the coffee make enter the presetting time state.)
3. Set the delayed starting time by pressing HOUR and
MINUTE button repetitively that is 13:00.
4. Press the DELAY BREW button, the indicator of ON/OFF
button is illuminated in green. After a while, the LED will
display the current clock. You may see the automatic start
time by pressing DELAY BREW.
USING YOUR COFFEE MAKER
1. Open the top lid and fill the water tank with drinking water.
The water level should not exceed MAX level as indicated
on the water gauge.
2. Place the funnel into the funnel support, make sure it is
assembled correctly, otherwise the top lid cannot be
closed. Place permanent filter in the funnel.
3. Add coffee powder into permanent filter. Usually a cup of
coffee needs a level spoon of coffee powder, but you may
adjust according to personal taste. Close the top lid
completely.
4. Insert the carafe with handle closed onto warming plate
horizontally.
5. Plug the power cord into the outlet. If you want to adjust
the coffee strength, you can press “STRENGTH” button
once, and then its corresponding indicator will illuminate
in orange and the appliance will brew thick coffee. If you
do not want to adjust the coffee strength, just follow the
following operation to brew normal coffee.
6. Press ON/OFF button, its indicator illuminates in red, the
LED display indicates “ 12:00”, and then the appliance
begins to work.
Note: The brewing process can be interrupted by pressing
the ON/OFF button at any time, and the indicator of
ON/OFF button will extinguish, indicating your coffee
maker is power off.
N o t e : D u r i n g b r e w i n g p r o c e s s , t h e b u t t o n s o f
“PROGRAM”,“DELAY BREW” ,“HOUR” and “MINUTE”
are invalid.
7. The brewing process can be interrupted by pressing the
ON/OFF button at any time, the indicator will extinguish.
The appliance will continue brewing once the ON/OFF
button is pressed again.
BEFORE THE FIRST USE
Check that all accessories are complete and the unit is not
damaged. Fill water into water tank to the MAX level and brew
water for several times without coffee powder, then discard
the water. Clean and dry all detachable parts thoroughly
according to the section “CLEANING AND MAINTENANCE”.
DELAY FUNCTION
If you do not want the coffee maker to start operation
immediately,
for example now it is 8:10, you hope that the coffee maker will
automatically start working at 13:00 , first follow steps 1 to 5
of above section, and then you can set the automatic start
function
as follows:
Note: You can take out the carafe, pour and serve at any
time. The appliance will stop dripping automatically. But the
time cannot exceed 30 seconds.
8. Remove out carafe to serve when finish brewing (about
one minute later after the coffee stops dripping out.)
Note:The coffee you get will be less than the water you have
added, as some water is absorbed by coffee ground.
9. When the process is finished, if you do not want to serve
immediately, keep the coffee maker is energized, the
coffee can be kept warm in the warming plate. And the
appliance will shut off automatically after 40 minutes from
the ON/OFF button being activated if it has not been
manually disconnected at the completion of brewing. For
an optimum coffee taste, serve it just after brewing.
10.Always turn the coffee maker off and disconnect the
power supply when not use.
NOTE: Pay attention to pour the coffee out, otherwise you
may be hurt as the temperature of coffee just finished is
high."