Geely EC715 2009, Workshop Manual

Page: 285 / 2181

Yes
System normal
No
Step 13 Test the cylinder pressure.
(a) Test the cylinder pressure. Refer to the "Engine Mechanical
System" in the.
Standard Cylinder Pressure: 800 kPa
All cylinders compression pressure equal to or higher than the
specified value?
Yes
Go to step 16
No
Step 14 Timing Chain Inspection.
(a) Turn off the ignition switch and remove the ignition key.
(b) For timing chain inspection. Refer to "Engine Mechanical
System" in the
2.6.8.11 Timing Chain Inspection .
Is timing chain positioned properly?
Yes
Go to step 16
No
Step 15
Install the timing chain.
(a) Turn off the ignition switch and remove the ignition key.
(b) Reinstall the timing chain. Refer to "Engine Mechanical
System" in the
2.6.8.10 Timing Chain Replacement .
Start the engine, fault solved?
Yes
System normal
No
Step 16
Check mechanical parts inside the engine.
(a) Remove the engine.
(b) Check the mechanical parts inside the engine. If necessary,
repair the damaged parts inside the engine.
(c) identify the damaged parts repair has been completed.
Next
Step 17
Diagnostic completed.
2.2.7.46 Idle Speed Reading Procedure
Must carry out this procedure if any of the following occurs:
– Disconnect battery cables.
Engine Control System JL4G18-D 2-203
EC718/EC718RV EC715/EC715RV 10/2009