Swivel Arm Hoist
GEDA STAR 200 STANDARD / GEDA STAR 250 COMFORT
NOTE
EMERGENCY STOP palm button switches are equipped with a stopping mechanism and
remain operated until they are un-locked again manually (turn red button to the right and pull
it back).
12 Dismantling (disassembly)
The swivel arm hoist must be dismantled according to the assembly and
operating instructions under the guidance of a qualified person determined
by the company! This qualified personnel must be familiar with the
assembly and operating instructions, have sufficient experience, and must
be instructed in the dangers involved in working with the swivel arm hoist.
The same regulations and safety notes as described in Chp. 9 apply for dismantling.
Also, make sure that disassembly is carried out generally in reverse order to assembly:
Cordon off danger zone and attach warning notices.
Disassembly is carried out in reverse order to assembly.
13 Malfunctions-Cause-Remedy
Faults may only be remedied by qualified personnel!
The load must be secured and/or detached prior to any troubleshooting!
ATTENTION
Remove mains plug before working on the electrical equipment of the lift.
Discontinue operation immediately if faults (e.g. damage to the wire rope) occur that
endanger operational safety!
Check the following if there are faults:
-
Mains feed line plugged in?
-
Fuses in the building site main cabinet? (16 A, slow-to-blow)
-
Correct extension cable? Cable cross section at least 3 x 2.5 mm²
-
Is the EMERGENCY STOP button unlocked?
-
Is the limit stop free and/or the limit switch not pressed?
-
Load suspension device overloaded?
-
Check miniature fuse in drive (63 mA slow-to-blow and 250 mA)
unplug unit, remove motor cover (3 screws SW 10).
Motor is not giving full output:
-
Fall in voltage of more than 10 % of the nominal voltage.
-
Select supply cable with higher wire cross section.
-
Reduce load.
-
If the motor is overheated, the integrated thermal switch turns off the actuator motor and
the control. - Work can continue after a certain cool-down period.
Assembly and Operating Manual
Page 27 of 38
BL107 GB Edition 01.2010
