CHANNEL FADERS
CHANNEL FADERS
MASTER OUTPUT SECTION
MASTER OUTPUT SECTION
8. MUTE
The MUTE switch when pressed in, cuts the signal sent to the main stereo LEFT and RIGHT outputs and to
the effects bus. By default, the AUX bus is muted by muting the channel.
9. MUTE LED
The MUTE LED indicator lights up red when the channel is muted.
10. CHANNEL FADER
Adjusts the level of the channel signal. Use these faders to adjust the balance between the various
channels.
11. PFL
(15.)
. This allows the particular channel signal to be checked. If many PFLs are selected, all are routed to
monitoring.
______________________________________________________________________________________
10
10
© GECKO MUSIC GROUP. All Rights Reserved.
12. AUX SEND
This is an impedance-balanced ¼” TRS output connector operating at +4dBu line level. The AUX SEND is
typically used to connect to an external effects unit or to a cue box or other such monitoring system, and for
special mix requirements.
13. AUX RETURN
This is impedance-balanced ¼” TRS input connector. The signal received by this input connector is sent to
the main stereo LEFT and RIGHT buses
(34.)
. This input connector is typically used to receive a return
signal from an external effects unit (i.e. reverb, delay, etc.).
14. FX SEND
If a jack is connected to the FX SEND
¼” TRS
connector, this will work as an extra AUX output
in
post-fader
(i.e. the signal routed to FX SEND is
affected
by the channel fader level).
No wet signal is sent to this output.
12
13
14
15
16
