7. FREQUENCY BAND SLIDERS
Each one of this slider potentiometer will boost or cut at its noted frequency by 6dB or 15dB, depending upon
the RANGE switch. When all the sliders are in the center demented position, the OUTPUT of the equalizer is
linear (flat). The frequency band centers of the GECKO® DESTINY EQ 7043 are marked at ⅓ or ⅔ of an
octave interval on ISO standard spacing.
8. LOW CUT SWITCH
The LOW CUT switch inserts or removes the 18dB/Octave 40Hz Bessel low-cut filter from the signal path.
When the LOW CUT switch is pressed in, the 18dB/Octave 40Hz Bessel low-cut filter is in the audio path.
REAR PANEL
9. POWER SWITCH
Switch the power ON [I] and OFF [O]. Always make audio connections with the power switch in the OFF
position.
10. IEC - AC POWER CORD RECEPTACLE
Plug the AC power cord (supplied) into the GECKO® DESTINY EQ 7043. Plug the other end into a standard
wall power outlet. Take care to route power cables away from audio lines.
WARNING:
Be sure to verify your actual line voltage is the same as the voltage level
printed below the AC power receptacle. Connection to an inappropriate power
source may result in extensive damage which is not covered by the warranty.
11. INPUTS
Three types of input connectors are provided for INPUT connections: female locking XLR type connectors,
¼” TRS connectors, and a barrier terminal strip. The maximum input level that the equalizer can accept is
+22dBu (ref: 0.775 Vrms).
______________________________________________________________________________________
3
3
© GECKO MUSIC GROUP. All Rights Reserved.
9
10
11
12
13
