GEBUWIN WW2000 D/FS Series, Operating Instructions Manual

Page: 13 / 30

12
Type A B C D E F G H I J K L M N P R S
WW2000 ../D/FS 410 310 196 360 376 279 166 147 42 133 25 312 372 62 380 437 220
WW3000 ../D/FS 436 365 251 386 405 292 167 174 50 165 25 376 443 47 380 527 220
WW4000 ../D/FS 436 365 251 386 405 292 167 174 50 165 25 376 443 47 380 527 220
WW5000 ../D/FS
436 460 316 386 405 315 167 172 79 219 25 437 495 60 380 604 220
WW2000 ../D/FSB 432 315 196 382 392 279 166 146 42 133 25 330 372 62 380 437 220
WW3000 ../D/FSB 458 365 251 386 427 292 167 182 50 165 25 376 443 47 380 527 220
WW4000 ../D/FSB 458 365 251 386 427 292 167 182 50 165 25 376 443 47 380 527 220
WW5000 ../D/FSB
458 460 316 386 427 315 167 184 79 219 25 437 495 60 380 604 220
3.1. Function description
The winches are drum winches with a worm gearing. The load is held at each required height by a built in load
pressure brake. The worm shaft and cable drum run on bearings. The housing is made of plate steel and is
suitable for mounting on walls, masts and the like. The crank is adjustable in length and removable. The
winches are fitted with a second drive shaft with another transmission.
The FS versions are equipped with the option to have the cable drum free spooling.
The FSB versions have the same free spooling option as the FS version but are also equipped with an
adjustable slipping clutch on the cable drum. This slipping clutch makes it possible to have a controlled
discharge of the cable in the free spool mode.
3.2. Mounting instructions
The winch must be mounted with the bolts as set out in chart 1.
To avoid tension build up in the winch housing, pay attention to the following:

there must be a smooth surface at the mounting bolt position

the wall or other construction must have sufficient carrying power

the level of the mounted winch must be checked with a spirit level in order to ensure good cable
movement.
All the nuts of the mounting bolts must be evenly fastened and secured.
3.3. Cable mounting
For the choice of cable, chart 1 must be consulted.
The cable must run-off upwards from behind the drum.
The cable is allowed to run-off backwards horizontally from
underneath the drum with the WW series as well as with some of
the models in the VL series.
Be careful!
The brake does not work in the case of an incorrect cable run-
off.
The cable length must be of sufficient length to allow for 3
windings to remain on the drum when in the lowest position.
The cable is mounted by means of the fixed cable clamp.
3.4. Before use
The winch is fitted with a worm wheel gearing. To ensure a long
lifespan we recommend that the winch be run in before use.
Allow the winch to make approx. 5 drum rotations whilst loaded
with approx. 50% of the nominal load. Remove the protection