Gebesa BENTO, Assembly Manual

Page: 5 / 8

ASCEND
BENTO HEIGHT-ADJUSTABLE DESK
ASCEND
BENTO HEIGHT-ADJUSTABLE DESK
5
USE
TROUBLESHOOTING
Make sure no obstacles are in the desk’s way.
Make sure the desktop is not touching any walls.
Make sure all cords have the appropriate length in order to adjust to the height.
IMPORTANT: You must RESET the desk prior to use.
RESET PROCEDURE: Press and hold the DOWN button on the handset until the desk reaches its lowest
height.
Release the DOWN button. Press and hold the DOWN button again until the LED display reads “RST”
for about 10 seconds.
On non-LED handset models:
Release the DOWN button. Press and hold the DOWN button again until the desk lowers a little bit
more, slightly rises and stops. Release the DOWN button.
Your desk is now ready to use.
The desk base can be adjusted by pressing and holding either the UP or DOWN button until the desired
height is reached.
To program up to four presets (on memory handsets): Use the up/down buttons to find a desired height,
then press “M” followed by a number 1-4.
CAUTION: Once a preset button is pushed, the desk will move to the programmed height (see caution
box above).
If your desk is not functioning properly it may need to be reset. Follow the RESET procedure outlined in
the USE section.
If your desk has a handset with an LED readout and it displays “RST” (reset), perform the reset procedure
outlined in the USE section.
If the LED readout displays an error message (”Er1" - “Er13") confirm that all wired connections are secure
(legs to cables, cables to control box). Then perform the reset procedure outlined in the USE section.
If the error message persists after the reset procedure, contact your seller.
If the height between the legs exceeds 1.5 inches, stop the reset procedure & contact your seller.
If the handset displays “HOT”, let the base cool down for 20 minutes.
2
12