Geberit Preda 116.085.00.1, Operation Manual

Page: 9 / 48

EN
Activating cleaning mode
• In cleaning mode, the flush actuation is
suppressed for 10 minutes. During this
time, you can clean the urinal or replace
the urinal trap.
• You can only activate cleaning mode
30 minutes after activating the power
supply or setting the flush time.
• You can also activate cleaning mode with
Geberit Clean Handy.
Prerequisite
– Refer to illustration sequence 1 ,
page
38
while carrying out the
instructions.
1
Hold a white sheet of paper in front
of the IR sensor on the bottom edge
of the urinal ceramic appliance for at
least 2 seconds.
2
Remove the white sheet of paper
after 2 short signal tones.
✓ The flush actuation is
deactivated and suppressed for
10 minutes. During this time,
you will hear a signal tone every
4 seconds.
3
Clean the urinal ceramic appliance
and replace the urinal trap.
Result
✓ Once 10 minutes have elapsed, a flush
is actuated.
Cleaning or replacing the
spray head
• Clean the cover for the spray head and
the nozzle with a mild, liquid cleaning
agent at least once a year.
• Descale the nozzle with a commercially
available descaling agent if necessary.
• Replace the nozzle if it can no longer be
completely cleaned and descaled.
Prerequisite
– Refer to illustration sequence 4 ,
page
41
while carrying out the
instructions.
1
Demount the urinal flush control to
disconnect the water supply. → See
illustration sequence 2 , page
39
.
2
Demount the cover for the spray
head.
3
Demount the nozzle.
4
Clean the nozzle and rinse with
water, or replace the nozzle (art. no.
243.333.00.1).
5
Mount the nozzle.
6
Mount the cover for the spray head.
7
Mount the urinal flush control. →
See illustration sequence 3 ,
page
40
.
Result
✓ The urinal is ready for operation.
7021420811-1 © 01-2020
969.653.00.0(00)
9