Gearmore GDL200, Assembly, Operation And Parts Manual

Page: 6 / 55

1. Wash and flush out sprayer after completion of each phase of your spraying program.
2. Flush out sprayer when changing chemicals, if there is a possibility of incompatibility.
3. Clean sprayer very thoroughly before storing at the end of the spraying season. If you
are in a cold climate, final rinse should be with a sufficiently concentrated anti-freeze to
prevent freeze-up in areas that were not thoroughly drained.
4. Check sprayer over for needed repairs before time to spray again.
5. Preparing the sprayer for use in the Spring means completion of all needed repairs,
installation of all drain plugs and checking sprayer for leaks with a tank of water.
SAFETY TIPS
‰
Sprayer should be operated only by qualified persons.
‰
Always
fill sprayer slowly to avoid spillage.
‰
When starting sprayer, maintain a safe distance from moving parts.
‰
Never
run P.T.O. at speeds in excess of 540 R.P.M.
‰
Do not
make adjustments when sprayer is running, unless specifically
recommended.
‰
Never
leave sprayer unattended while it is running.
‰
Keep hands, feet and clothing away from all moving parts.
‰
Handle chemicals carefully; follow the manufacturer's directions for mixing and
applying chemicals.
CLEANING & STORAGE
Page 4