5
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
www.GEAppliances.com
When the air conditioner is turned on, it will
automatically start in the setting last used,
except the timer will be cancelled if it was set.
Lights in the display or beside the touch pads
on the air conditioner control panel indicate the
selected settings.
Use the
COOL
mode with
HIGH, MED
or
LOW
fan
for cooling. Use the
Increase
▲
/ Decrease
▼
pads
to set the desired temperature between 60°F and
90°F in 2°F increments (or between 16°C and
31°C in 1°C increments if the control has been
set to use Celsius).
A thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air
will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE:
If the air conditioner is off and is then turned on while
set to
COOL
, it will take approximately 3 minutes for the
compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—
Select the
COOL
mode and
HIGH
or
MED
fan with a middle set temperature.
For Maximum Cooling—
Select the
COOL
mode
and
HIGH
fan with a lower set temperature.
For Quieter & Nighttime Cooling—
Select the
COOL
mode and
LOW
fan with a middle set
temperature.
NOTE:
If you switch from a
COOL
setting to
OFF
or to
a fan setting, wait at least 3 minutes before switching back
to a
COOL
setting.
COOL Mode
Use the
FAN
at
HIGH, MED
or
LOW
to provide
air circulation and filtering without cooling.
Since fan only settings do not provide cooling,
a temperature setting will not be displayed.
Your control is set to use and display Fahrenheit temperature
selections, but you may change it to use and display Celsius
selections.
Press and hold the
Increase
▲
/ Decrease
▼
pads
at the same time to switch to ˚C or ˚F as desired.
FAN Mode
Fahrenheit or Celsius
The vent control is located on the inside of the
air louvers at the bottom of the vent.
When set at
CLOSE
, only the air inside the room
will be circulated and conditioned. When set at
OPEN
, some inside air is exhausted outside.
Vent Control
Up and Down
Fingertip pressure on the horizontal louvers
adjusts the air direction up or down.
Side-to-Side
The side-to-side air direction is adjusted by moving
the air direction lever to the left or right.
Air Direction
To open the vent.
To close the vent.
Vent control
lever
Vent control
lever
Air direction
lever
