GEAppliances.com
COOL Mode
Use the
COOL
mode with
HIGH, MED
or
LOW
fan
for cooling. Use the
TEMPERATURE INCREASE
▲
/
DECREASE
▼
pads to set the desired temperature
between 64°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the
room temperature. The compressor will cycle on
and off to keep the room at the set level of comfort.
Set the thermostat at a lower number and the indoor
air will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE:
If the air conditioner is off and is then turned on
while set to
COOL
, it will take approximately 3 minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—
Select the
COOL
mode and
HIGH
or
MED
fan with a middle set temperature.
For Maximum Cooling—
Select the
COOL
mode
and
HIGH
fan with a lower set temperature.
For Quieter & Nighttime Cooling—
Select the
COOL
mode and
LOW
fan with a middle set
temperature.
NOTE:
If you switch from a
COOL
setting to
OFF
or to a fan
setting, wait at least 3 minutes before switching back to a
COOL
setting.
FAN Mode
Use the
FAN
at
HIGH, MED
or
LOW
to provide air
circulation and filtering without cooling. Since fan
only settings do not provide cooling, a temperature
setting will not be displayed.
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
Vent Control
The vent control is located above the control
panels.
When set at
CLOSE
, only the air inside the room
will be circulated and conditioned. When set at
OPEN
, some outside air is let into the room.
To open the vent, push the lever to the right.
To close it, push it to the left.
5
Air Direction—Up and Down
Fingertip pressure on the horizontal louvers
adjusts the air direction up or down.
In the case of a power outage or interruption, the
unit will automatically re-start in the settings last
used after the power is restored. The
TIMER
feature
will reset to the original setting. You may need to set
a new time if desired.
Power Outage Recovery Feature
Control Panel Door
Press to open and close the door.
