GEA ONE 11TS, Instructions For Use And Maintenance Manual

Page: 106 / 301

ONE 7TS – Maintenance
7.2. Instructions for correct maintenance
7.2.1 For good maintenance:
Use only original spare parts and appropriate tools in good condition.
Comply with the service frequencies indicated in the preventive and periodic maintenance; the interval (indi-
cated in time or work cycles) between procedures is meant as the maximum period and should not be ex-
ceeded. If needed the interval can be shorter.
Correct preventive maintenance requires constant attention and continuous supervision of the machine.
Promptly check the cause of problems such as excessive noise level, overheating, leaking , etc. and find a
solution.
In case of doubt contact the manufacturer.
To perform maintenance procedures corrects, refer to the documents attached, and.g.:
1) – Functional diagrams for electrical and auxiliary equipment, with indications of power connections.
2) – List of possible failures and recommended solutions (chapter 8 del manuale).
7.2.2 Maintenance plan
From a construction point of view the procedures regard mechanical, electrical, (fluidic) parts.
For practical reasons, the procedures are grouped according to time and complexity criteria. Each procedure
or group of procedures can deal with mechanical, electrical, (fluidic) aspects.
Ordinary maintenance can be divided in two categories:
•
ordinary scheduled
maintenance (or preventive).
•
ordinary
maintenance
according to condition
.
Ordinary scheduled maintenance (also referred to as periodic or preventive) includes inspections, checks
and procedures, to prevent shutdown and failures, to systematically verify:
•
machine lubrication condition
•
condition of parts subject to wear.
Ordinary maintenance according to condition regards machine components that are not subject to periodic
checks and previously quantifiable wear. They must be checked or replaced depending on their condition.
ATTENTION:
All proceldures must be performed by qualified technicians after setting the machine to maintenance
mode,
i.and. with
MACHINE OFF
and the master switch
BLOCKED
(with padlock)
ON OPEN POSITION
,
for personnel safety
.
pag 7.3
The presente manuale è of proprietà
GEA Niro Soavi S.p.A.
every riproduzione, anche parziale, è vietata.