Maintenance
Check bottom translucent hose of suspension cylinders
2018-9015-001
09-2016
9.11
Check hydraulic suspension
Before each use or every 10 hours
● Park the spreader on a flat and level
surface;
● Measure the length of the
suspension rod (X), the dimension
must be 6” (15 cm);
● If length is not appropriate, refer to
section Maintenance - Hydraulic
suspension.
Note!
The tire is removed for better understanding.
9.12
Check bottom translucent hose of suspension cylinders
Before each use or every 10 hours
Note!
This section concerns a standard suspension with oil on the upper side
of pistons. It is not applicable for the optional suspension cylinder with
oil on both sides of piston.
Note!
Use MV 22 HYDREX
TM
hydraulic fluid (or equivalent).
● Remove the hose (1) from the frame;
● Add hydraulic oil in the hose until it is
covered with oil (2), as shown
hereafter;
● Insert the hose in the frame;
● Repeat these steps for each
suspension cylinder.
1
2