– 12 –
Freezer Compartment
To remove the freezer compartment:
1. Remove ice storage bin, drawer, and shelves.
2. Remove the freezer thermistor cover. Unclip
the freezer thermistor from the holding
bracket.
3. Remove the control panel.
4. Remove the 3 Phillips-head screws from the
top-front of the freezer compartment.
5. Remove the 4 Phillips-head screws from the
rear of the freezer compartment.
8. Pull the freezer compartment forward as
shown until clear.
6. Pull the freezer compartment forward
approximately 2 to 3 inches inches to access
the icemaker plug and groundwire.
7. Disconnect the icemaker plug. Disconnect the
ground wire at the fi ll tube heater.
Thermistor
6-Pin Connector
9. Reverse the procedure to install.
Caution:
Make sure the 6-pin connector is pushed
down and out of the way when sliding
the freezer compartment back into place.
Damage to the 6-pin connector can result.
Make sure the freezer thermistor does not get
pinched when sliding the freezer compartment
back into place.
•
•
