GE ZEK957 Series, Technical Service Manual

Page: 18 / 70

– 16 –
3. Remove 2 screws from each side of the door
on the liner.
4. Separate the liner assembly and the outer glass
assembly.
5. Remove 2 screws from the door handle near
the door vent trim.
6. Slide the bottom trim and the top vent trim out to
free the outer door glass.
7. Reassemble in reverse order.
To replace liner assembly:
1. Remove 3 screws on each side of the door liner
to remove the door hinge assembly.
2. Remove 4 screws from the insulation retainer.
3. Remove 6 screws and the insulation retainer.
The window pack and window gasket are now
accessable on units with a window door.
Caution: Care must be taken when mounting door
handle not to overtighten screws. Overtightening
screws can damage handle. Hand tighten ONLY.
Make sure handle fits snug to door panel.
Oven Door Gasket
The gasket forms a seal around the front edge of
the oven liner and the inner door panel except for
approximately a 6-in. opening at the center bottom.
The gasket is attached to the inner door panel by a
chain of spring clips.
To remove door gasket:
1. Open the door completely.
2. Pull the end of the gasket out of the slots at the
bottom of the door.
3. Finish removing the gasket by placing a finger
under the gasket beside the clip and pulling
straight up.
To install gasket:
1. Locate the 2 clips on the gasket just right and
left of center.
Note: The gasket will go on easier if folded 90
degrees at the clip being inserted.
2. Place a finger on top of the spring clip and press
into the 2 center top holes in the inner door
panel.
2 Screws
Window
Pack and
Gasket
6 Screws
4 Screws
3 Screws