(continued)
How to Use the Soak Cycle
●
Soak Cycle
temperature will
automatically
be cold.
●
For a hot or warm
soak, set the
Temp.
control to HOT/COLD or WARM/COLD and
turn the Cycle Selector knob to NORMAL in the
Regular Cycles.
Start the washer. After washer fills and begins to
agitate, push in the Cycle Selector knob and turn
to SOAK CYCLE. Pull out the Cycle Selector knob
to complete the cycle.
●
For an extended soak, allow the washer to fill and
agitate for a few minutes to dissolve the soaking
agent. Then push in the Cycle Selector knob to stop
the washer (keep lid closed) and allow to soak for as
long as desired. After desired soak period, pull out the
Cycle Selector knob to complete the cycle.
If your clothes and household
items don’t look clean and fresh
after washing, you will probably
rewash them... and that means
you’ll waste energy. Remember
to sort your clothes carefully,
and load them properly, select
correct cycles, use enough
detergent and
choose a
temperature warm enough to
release and
rid of soil.
●
Use Hot Wash—up to
a regular basis
only
when washing heavily
soiled articles-such as work
and play clothes.
●
Under normal soil conditions,
wash in water above
This generally
means using the Warm Wash
temperature setting on your
washer—temperatures
approximately
or hand
comfortable. If you notice
that soil has accumulated after
several consecutive washings,
use Hot Wash occasionally, if
safe for fabrics.
●
Try to wash less often. Save
articles of the same type of
fabric until you have a full load.
●
If you must wash smaller loads,
adjust the amount of water.
Small loads should have lower
water levels.
●
Wash in off-peak utility hours.
Your local utility can tell you
which are the off-peak hours.
8