OTHER
Possible Causes
What To Do
Labels on the exterior
Occasionally the adhesive
•
Use a hair dryer set at the lowest heat setting, directing
of the washer will not
used on the labels does
the air at the label for a short amount of time. This will
peel off cleanly
not release cleanly
release the adhesive easily, without damaging the surface
of the washer.
NOISE
Possible Causes
What To Do
Washer is noisy
Washer is uneven
•
To level the front of the washer, adjust the front leveling
legs by rotating the individual leg in the proper direction
for up or down. To level back of washer, lift back of
machine 4
″
(11 cm) and set down.
Washer load is
•
Push the Cycle knob in to stop the washer, open the lid
unbalanced
and redistribute the load evenly. Close the lid and restart.
Shipping plug is still assembled
•
See Installation Instructions for details on removing
in unit
shipping plug.
Washer is sitting too close
•
Pull washer away from the wall; about 4
″
(11 cm)
to wall (causes knocking
is needed.
during cycle)
Operating Instructions
Safety Instructions
Consumer Support
Troubleshooting T
ips
14
Before you call for service…
Troubleshooting Tips